Camper Project
Friday, 3 April 2020
Roof Cover
I had a piece of vinyl sheeting from an earlier project and used this to cover the roof.
Frames had been installed on the underside to suit the roof lights and these were first opened up with the trim router.
Then the vinyl was secured using strips of contact adhesive at 300mm centres.
No comments:
Post a Comment
Newer Post
Older Post
Home
Subscribe to:
Post Comments (Atom)
Laminate Floor
Laminated Floor strength test. Following a bit of research into floor construction I decided to experiment with the creation of a laminate...
(no title)
The drawings: One of the other objectives and reason that the camper is planned as a demountable is that vehicle and unit will fit int...
First Window Trial
The edges of the vinyl roof were trimmed back and a cover of angled checkerplate installed at the edges for protection. The first window...
No comments:
Post a Comment